Sense[1]]|Sense2:Average[:State] <Boolean> - Agilent Technologies EPM-P Series Programming Manual

[SENSe[1]]|SENSe2:AVERage[:STATe] <boolean>
This command is used to enable and disable averaging.
Syntax
SENS
SENS2
Example
AVER 1
Reset Condition
On reset, averaging is enabled.
Query
[SENSe[1]]|SENSe2:AVERage[:STATe]?
The query enters a 1 or 0 into the output buffer indicating the status of
averaging.
•
•
Query Example
SENS2:AVER?
Error Messages
If [SENSe[1]]|SENSe2:AVERage:STATe is set to ON while
[SENSe[1]]|SENSe2:SPEed is set to 200, the error -221, "Settings
Conflict" occurs.
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
[SENSe[1]]|SENSe2:AVERage[:STATe] <boolean>
:
AVER
1
1 is returned when averaging is enabled.
0 is returned when averaging is disabled.
SENSe Subsystem
Space
:STAT
This command enables averaging
on channel A.
This command queries whether
averaging is on or off for channel B.
0|OFF
1|ON
?
9-13