Service:sensor[1]|2:Radc? - Agilent Technologies EPM-P Series Programming Manual

SERVice Subsystem

SERVice:SENSor[1]|2:RADC?

SERVice:SENSor[1]|2:RADC?
This query returns a new raw uncorrected measurement in volts, as a
32 bit signed integer.
Note For E9320 Series sensors:
before running this query, the voltage to corrected power conversion
must be disabled using the
SERVice:SENSor[1]|2:CORRections:STATe command.
Syntax
SERV
Example
SERV:SENS2:RADC?
Error Messages
• If INIT:CONT is set to ON, error -221 "Settings Conflict" occurs.
• If an E9320 Series sensor is connected and
SERVice:SENSor[1]|2:CORRections:STATe is set to ON, error -221
"Settings Conflict" occurs.
15-24
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
:SENS :RADC
1
2
EPM-P Series Power Meters Programming Guide
?
This query returns a new raw
uncorrected measurement for the
sensor connected to channel B.