Abort Subsystem; Description; Syntax Diagram And Command Descriptions - Agilent Technologies 8960 Series Reference Manual

Hide thumbs Also See for 8960 Series:

Table of Contents

ABORt Subsystem

The ABORt command causes a measurement cycle in progress to stop. If the measurement is not being

continuously armed (trigger arm set to single) , the measurement will remain in the idle state after this event.

If the measurement is being continuously armed (trigger arm set to continuous), a new measurement cycle

will begin after ABORt. If an ABORt command is issued from any measurement state other than measuring,

the command is ignored.

Other Commands that Execute an ABORt Action

INITiate:<meas> will execute an ABORt:<meas> as part of the INITiate:<meas> command.

READ:<meas>? will execute an ABORt:<meas> action that aborts just one trigger sequence and then

combines the INITiate and FETCh? commands.

S:\Hp8960\E1963A WCDMA\4.0 release\Reference Guide\Chapters\wcdma_hpib_abort_description.fm