4349B
ABORt Command
:ABORt
The
command resets the trigger system and places all trigger sequences in the IDLE
state. Any actions related the trigger system that are in progress, such as acquiring a
measurement, are aborted immediately. The execution of an
pending operation
ags to false, for example
ags that were set by the initiation of the trigger
system. See \Trigger System".
Unlike
,
does not alter the settings programmed by other commands. (No query)
Note
After
the
query,
command causes the GPIB bus to hang up. To avoid this, before
command execution, clear the gpib bus with the BASIC command
( address ).
command, or the BASIC command
ABORt Command
command will set any the
,
GPIB Reference
5-9