Agilent Technologies EPM-P Series Programming Manual page 7

About this Guide
Chapter 9: SENSe Subsystem
This chapter explains how the SENSe command subsystem directly affects
device specific settings used to make measurements.
Chapter 10: STATus Subsystem
This chapter explains how the STATus command subsystem enables you
to examine the status of the power meter by monitoring the "Device
Status Register", "Operation Status Register" and the "Questionable
Status Register".
Chapter 11: SYSTem Subsystem
This chapter explains how to use the SYSTem command subsystem to
return error numbers and messages from the power meter, preset the
power meter, set the GPIB address, set the command language and query
the SCPI version.
Chapter 12: TRACe Subsystem
This chapter explains how to use the TRACe command subsystem to
configure and read back the measured power trace.
Chapter 13: TRIGger Subsystem
This chapter explains how the TRIGger command subsystem is used
synchronize device actions with events.
Chapter 14: UNIT Subsystem
This chapter explains how to use the UNIT command subsystem to set the
power meter measurement units to Watts and % (linear), or dBm and dB
(logarithmic).
Chapter 15: SERVice Subsystem
This chapter explains how to use the SERVice command subsystem to
obtain and set information useful for servicing the power meter.
Chapter 16: IEEE488.2 Command Reference
This chapter contains information about the IEEE488.2 Common
Commands that the power meter supports.
vi EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com