Gsm900: Power Meter Presets: Window/Measurement Settings - Agilent Technologies EPM-P Series Programming Manual

SYSTem Subsystem
SYSTem:PRESet <character_data>
Command
TRIG[:SEQ]:DEL
TRIG[:SEQ]:HOLD
Step detection
[SENSe[1]]|SENS2:AVER:SDET
Trace setup
DISP[:WIND[1]|2]:TRAC:LOW
DISP[:WIND[1]|2]:TRAC:UPP
[SENS[1]]|SENS2:TRAC:OFFS
:TIME <numeric_value>
[SENS[1]]|SENS2:TRAC:TIME
<numeric_value>
Table 11-3: GSM900: Power Meter Presets: Window/Measurement Settings
Function
Display setup
Upper window
Lower window
Window/measurement setup
Upper window/upper measurement (UU)
Feed
Measurement
Upper window/lower measurement (UL)
Feed
Measurement
Lower window/upper measurement (LU)
Feed
Measurement
Lower window/lower measurement (LL)
Feed
Measurement
1. For further information refer to "Primary and secondary channels", on page 11-29.
11-36
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Setting
20 us Delay between recognition of
trigger event and start of a
measurement
4275 us Trigger holdoff
1 Step detection enabled
+20 dBm Maximum power
-35 dBm Minimum power
-40 us Delay between delayed trigger
point and the start of the trace
700 us Length of the trace
Setting
No Sensor
Channel A trace
LU single numeric
N/A
N/A
N/A
N/A
Gate 1 Channel A
Avg
DEF
DEF
Agilent E4416A/E4417A Programming Guide
Comments
Non E9320 Sensor
1
Primary channel trace
See Table 11-4
N/A
N/A
N/A
N/A
1
Gate 1 primary channel
Avg
See Table 11-4
See Table 11-4