Output:recorder[1]|2:Feed <Data_Handle> - Agilent Technologies EPM-P Series Programming Manual

OUTPut:RECorder[1]|2:FEED <data_handle>
This command specifies which measurement is sent to the recorder output
specified by the numeric value following RECorder. RECorder1 applies to
both single and dual channel power meters. RECorder2 applies to dual
channel power meters only.
Syntax
OUTP
Parameters
Item
data_handle
Example
OUTP:REC2:FEED "CALC1"
Reset Condition
On reset, data_handle is set to its previous value.
Query
OUTPut:RECorder[1]|2:FEED?
The query command returns the current value of data_handle.
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
OUTPut:RECorder[1]|2:FEED <data_handle>
:REC 1 :FEED
2
Description/Default
The CALC block specifying the
measurement to be sent to the
recorder output.
OUTput Subsystem
Space data_handle
?
Range of Values
"CALC1" or "CALC"
"CALC2"
"CALC3"
"CALC4"
This command sends the CALC1
measurement to recorder output 2.
8-3