Sense[1]]|Sense2:Trace Commands - Agilent Technologies EPM-P Series Programming Manual

SENSe[1]]|SENSe2:TRACe Commands

These commands are used to set:
•
•
•
•
Note These commands can only be used with E9320 sensors which are set
to NORMal mode.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:TRACe:LIMit:LOWer <numeric_value>
[SENSe[1]]|SENSe2:TRACe:LIMit:UPPer <numeric_value>
[SENSe[1]]|SENSe2:TRACe:OFFSet:TIME <numeric_value>
[SENSe[1]]|SENSe2:TRACe:TIME <numeric_value>
[SENSe[1]]|SENSe2:TRACe: UNIT <character_data>
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The upper and lower limits for the trace display.
The delay between the delayed trigger point and the start of the
trace.
The duration of the trace.
The trace units.
SENSe Subsystem
SENSe[1]]|SENSe2:TRACe Commands
9-57