Agilent Technologies EPM-P Series Programming Manual page 245

CALCulate Subsystem
CALCulate[1]|2|3|4:RELative Commands
CALCulate[1]|2|3|4:RELative Commands
These commands compare the measurement signal to a reference value.
Within the CALCulate block the relative value is applied to the
measurement signal after any math calculations and display offsets have
been applied.
The commands described in this section:
CALCulate[1]|2|3|4:RELative[:MAGNitude]:AUTO
<boolean>|ONCE
CALCulate[1]|2|3|4:RELative:STATe <boolean>
3-30 EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com