Agilent Technologies EPM-P Series Programming Manual page 219

CALCulate Subsystem
CALCulate[1]|2|3|4:FEED[1]|2 <string>
CALCulate[1]|2|3|4:FEED[1]|2 <string>
This command sets the input measurement mode to be fed to the specified
input on the CALC block. It is applied to the measurement after the
CALC:MATH:EXPR command has been used to specify which channel the
feed will be taken from.
Measurement modes are coupled for combination measurements (for
example, ratio measurements). For example, if one feed is changed to
PTAV, the other is automatically changed to PTAV.
Under certain circumstances the measurement mode may be changed by
the CALC:MATH:EXPR command. Refer to page 3-26 for further
information.
Syntax
CALC
3-4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1 :FEED 1
2 2
3
4
EPM-P Series Power Meters Programming Guide
Space
string
?