System:communicate:serial Commands - Agilent Technologies EPM-P Series Programming Manual

SYSTem Subsystem

SYStem:COMMunicate:Serial Commands

SYStem:COMMunicate:Serial Commands
These commands control the settings for the RS232/RS422 serial
interface. The commands allow you to:
•
•
•
•
•
•
The following commands are detailed in this section:
SYSTem:COMMunicate:SERial:CONTrol:DTR
SYSTem:COMMunicate:SERial:CONTrol:RTS
SYSTem:COMMunicate:SERial:[:RECeive]:BAUD
SYSTem:COMMunicate:SERial:[:RECeive]:BITs
SYSTem:COMMunicate:SERial:[:RECeive]:PACE
SYSTem:COMMunicate:SERial:[:RECeive]:PARity:[TYPE]
SYSTem:COMMunicate:SERial:[:RECeive]:SBITs
SYSTem:COMMunicate:SERial:TRANsmit:AUTO?
SYSTem:COMMunicate:SERial:TRANsmit:BAUD
SYSTem:COMMunicate:SERial:TRANsmit:BITs
SYSTem:COMMunicate:SERial:TRANsmit:ECHO
SYSTem:COMMunicate:SERial:TRANsmit:PARity:[TYPE]
SYSTem:COMMunicate:SERial:TRANsmit:SBITs
11-6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Set the function of the DTR and RTS signal lines.
Set the transmit/receive baud rate.
Set the transmit/receive word length.
Set the transmit/receive parity type.
Set the transmit/receive stop bits.
Enable /disable XON/XOFF software handshaking.
Agilent E4416A/E4417A Programming Guide