Agilent Technologies EPM-P Series Programming Manual page 385

SENSe Subsystem
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3[:INPut][:MAGNitude]
Query Example
CORR:GAIN3?
Error Messages
• If a duty cycle value is entered using
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3 while
[SENSe[1]]|SENSe2:SPEed is set to 200, the error -221, "Settings
Conflict" occurs. However, the duty cycle value is set but the
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe command
is not automatically set ON.
• If this command is used when an E-Series power sensor is connected,
the error -310, "System error;Dty Cyc may impair accuracy with ECP
sensor" occurs. If you are using the E4417A the error message specifies
the channel.
9-32
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
This command queries the current
setting of the duty cycle for
channel A.
EPM-P Series Power Meters Programming Guide