Service:sensor[1]|2:Corrections:state <Boolean> - Agilent Technologies EPM-P Series Programming Manual

SERVice Subsystem
SERVice:SENSor[1]|2:CORRections:STATe <boolean>
SERVice:SENSor[1]|2:CORRections:STATe <boolean>
This command enables/disables the voltage to corrected power conversion.
It applies to E9320 Series power sensors only.
Note Before setting this command to OFF, you must set the INIT:CONF
command to OFF.
After setting this command to OFF, you must only run commands
relating to the gathering of ADC values—for example, the
SERV:SENS:RADC command.
Syntax
SERV
Example
SERV:SENS2:CORR:STAT ON
Reset Condition
On reset, the value is set to OFF.
Query
SERVice:SENSor[1]|2:CORRections:STATe?
The query enters a 1 or 0 into the output buffer indicating the status of
the voltage to corrected power conversion.
• 1 is returned when voltage to corrected power conversion is enabled.
• 0 is returned when voltage to corrected power conversion is disabled.
15-14
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
:SENS 1 :CORR
2
Space
:STAT
This command enables the voltage
to corrected power conversion for
channel B.
EPM-P Series Power Meters Programming Guide
0|OFF
1|ON
?