Rs232/Rs422 Configuration - Agilent Technologies EPM-P Series Programming Manual

Power Meter Remote Operation
Configuring the Remote Interface

RS232/RS422 Configuration

The RS232/RS422 serial port on the rear panel is a nine pin D-type
connector configured as a DTE (Data Terminal Equipment). For pin-out
information and cable length restrictions refer to the EPM-P Series Power
Meters User's Guide.
You can set the baud rate, word length, parity, number of stop bits,
software and hardware pacing, either remotely or from the front panel.
For front panel operation refer to the EPM-P Series Power Meter User's
Guide. For remote operation use the following commands:
SYSTem:COMMunicate:SERial:CONTrol:DTR
SYSTem:COMMunicate:SERial:CONTrol:RTS
SYSTem:COMMunicate:SERial[:RECeive]:BAUD
SYSTem:COMMunicate:SERial[:RECeive]:BITs
SYSTem:COMMunicate:SERial[:RECeive]:PACE
SYSTem:COMMunicate:SERial[:RECeive]:PARity[:TYPE]
SYSTem:COMMunicate:SERial[:RECeive]:SBITs
SYSTem:COMMunicate:SERIal:TRANsmit:AUTO?
SYSTem:COMMunicate:SERial:TRANsmit:BAUD
SYSTem:COMMunicate:SERial:TRANsmit:BITs
SYSTem:COMMunicate:SERial:TRANsmit:ECHO
SYSTem:COMMunicate:SERial:TRANsmit:PACE
SYSTem:COMMunicate:SERial:TRANsmit:PARity[:TYPE]
SYSTem:COMMunicate:SERial:TRANsmit:SBITs
1-4 EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com