Power Cord Specifications - Cisco Firepower 1010 Series Hardware Installation Manual

Power Cord Specifications

PID
FPR1K-DT-PWR-AC=
FPR1K-DT-RACK-MNT=
FPR1K-DT-WALL-MNT=
FPR1K-DT-FIPS-KIT=
Power Cord Specifications
Each power supply has a separate power cord. Standard power cords or jumper power cords are available for
connection to the security appliance. The jumper power cords for use in racks are available as an optional
alternative to the standard power cords.
If you do not order the optional power cord with the system, you are responsible for selecting the appropriate
power cord for the product. Using a incompatible power cord with this product may result in electrical safety
hazard. Orders delivered to Argentina, Brazil, and Japan must have the appropriate power cord ordered with
the system.
Note
The following power cords are supported.
Figure 10: Argentina (CAB-AC-C5-ARG)
1
3
Cisco Firepower 1010 Series Hardware Installation Guide
16
Only the approved power cords or jumper power cords provided with the chassis are supported.
Plug: IRAM 2073
Connector: IEC 60320/C5
Description
Cisco Firepower 1010 and 1010E 150-W power
supply (spare)
Cisco Firepower 1010 and 1010E rack-mount kit
(spare)
Cisco Firepower 1010 and 1010E wall-mount kit
(spare)
Cisco Firepower 1010 FIPS kit (spare)
2 Cord set rating: 2.5 A, 250 V
—
Overview