Power Supply Modules - Cisco Firepower 9300 Hardware Installation Manual

Power Supply Modules

Cable and operating
distance
Table 5: 10-Gb LR Network Module (FPR9K-NM-6X10LR-F)
Insertion loss
Cable and operating
distance
Power Supply Modules
The Firepower 9300 supports two AC, two DC, or two high-voltage DC (HVDC) power supply modules so
that dual power supply redundancy protection is available. Facing the front of the chassis, the power supply
modules are numbered left to right, for example, PSU-1 and PSU-2.
Attention Make sure that one power supply module is always active.
AC Power Supply Modules
Cisco Firepower 9300 Hardware Installation Guide
26
Core diameter (microns)
62.5
62.5
50
50
50
50
Operating Mode
Normal
Hardware bypass
Core diameter (microns)
G.652
The 220-V power supply modules run at 2500 W for 200 to 240 V AC. The load is shared when both
power supply modules are plugged in and running at the same time. The power supply modules support
Modal bandwidth Cable distance
(MHz/km)
Note
160 (FDDI) 13 m
200 (OM1) 16.5 m
400 33 m
500 (OM2) 41 m
2000 (OM3) 150 m
4700 (OM4) 200 m
Typical Maximum
1.2 dB 1.6 dB
1.5 dB 1.9 dB
Modal bandwidth Cable distance
(MHz/km)
Note
Single mode 5 km
Overview
Half the
distance
specified by
the IEEE
standard.
Half the
distance
specified by
the IEEE
standard.