Procedure: Verify Successful Turn-Up Of Mics; Figure 1-13 Ons 15327 Slot Numbering - Cisco ONS 15327 User Documentation

Hide thumbs Also See for ONS 15327:
Table of Contents

Advertisement

Chapter 1
Hardware Installation

Figure 1-13 ONS 15327 slot numbering

Note
Because all high-speed cards boot from the working XTC card, at least one XTC card must be installed
in order to boot any high-speed cards.
Warning
Invisible laser radiation can be emitted from the aperture port when no cable is connected. To avoid
exposure to laser radiation and do not stare into open apertures.

Procedure: Verify Successful Turn-Up of MICs

Install MIC A in Slot 8.
Step 1
The slots are keyed to ensure that cards are installed in the correct slot.
Verify that the power and ground cables are installed correctly.
Step 2
With power applied to MIC A, insert the fan-tray assembly and verify that the fans activate.
Step 3
The fans will only activate if at least one XTC card is installed.
If you require redundant power, more than 14 DS-1s, or you are using DS-3s, install MIC B in Slot 7. If
Step 4
MIC B is not required, proceed to
With power applied to MIC B, unplug MIC A from the backplane (do not remove it completely) and
Step 5
verify that the fans are still running.
Disconnect power before removing MICs from the ONS 15327.
Warning
Plug MIC A back into the backplane and reconnect power.
Step 6
Verify that the card appears in the correct slot on the CTC node view (default login) screen.
Step 7
Verify that the card is white on the CTC node view screen.
Step 8
If MIC A was unplugged in
Step 9
slot and is white on the CTC node view screen.
Refer to
June 2002
Slot 4
4
Slot 3
3
Slot 2
2
Slot 1
1
Step
Step
5, plug it back into the backplane and verify that it appears in the correct
Chapter 2, "Software Installation,"
Slot 5
Slot 6
Slot 7
Slot 8
7.
for more information about using CTC.
Cisco ONS 15327 User Documentation, R3.3
Card Installation and Turn-Up
5
Fan
Tray
6
Slot
7
8
1-19

Advertisement

Table of Contents
loading

Table of Contents