Table of Contents
Advertisement
11-024-120, 11-025-120 Paddle Roll Failure RAP
11-024-120 The paddle is not at the home position.
11-025-120 The paddle fails to rotate.
NOTE: The home position of the paddle is when the sensor flag is located between the sensor
jaws. Jams will occur in the compiler and bin 1 cannot be used.
Initial Actions
Check the following:
•
That there is no paper or other obstructions in the vicinity of the paddle.
•
The paddle roll position sensor bracket is holding the sensor in the correct position, i.e.
the flag is in the middle of the sensor gap and the sensor does not touch any moving com-
ponents.
•
Check that paper type is set correctly. If heavyweight paper is used but not set in the UI,
the compiler capacity can be exceeded. Refer to 11H-120 Mis-Registration in Stapled
Sets and Non-stapled Sets RAP.
•
Check the position of the paddles. With the paddle roll in the home position both sets of
paddles must be within the output cover, if they are not, refer to REP 11.10-120 Paddle
Wheel Shaft Assembly. If any of the paddles are out of alignment to other paddles, install
a new paddle wheel shaft assembly, PL 11.104 Item 4.
•
1K LCSS PWB DIP switch settings, refer to 11E-120 1K LCSS PWB DIP Switch Settings
RAP.
Procedure
NOTE: All 1K LCSS interlocks must be made to supply +24V to the motors.
NOTE: In diagnostics, actuating any 1K LCSS sensor or switch can change the displayed state
on the UI. Make sure that the correct sensor or switch is tested.
Enter dC330, codes 11-024, paddle home position and 11-025, paddle run. The
rotates correctly.
Y
N
Go to Flag 2. Check the paddle motor, MOT 11-024.
Refer to:
•
11F-120 1K LCSS PWB Damage RAP.
•
GP 10, How to Check a Motor.
•
Figure 1.
•
P/J14, 1K LCSS PWB.
•
11C-120 1K LCSS Power Distribution RAP
Repair or install new components as necessary:
•
Paddle motor, PL 11.104 Item 10.
•
1K LCSS PWB, PL 11.124 Item 1.
Enter dC330, code 11-025 and stack the code 11-326, to actuate the paddle roll position sen-
sor Q11-326. The display cycles high/low.
Y
N
Go to Flag 1. Check Q11-326.
A
Status Indicator RAPs
11-024-120, 11-025-120
A
Refer to:
•
11F-120 1K LCSS PWB Damage RAP.
•
GP 11, How to Check a Sensor.
•
Figure 1.
•
P/J2, 1K LCSS PWB
•
11C-120 1K LCSS Power Distribution RAP
Repair or install new components as necessary:
•
Paddle roll position sensor, PL 11.104 Item 11.
•
1K LCSS PWB, PL 11.124 Item 1.
Perform SCP 6 Final Actions.
paddle
Figure 1 Component location
August 2007
2-340
Paddle roll position
sensor
Q11-326
Paddle motor
MOT11-024
WorkCentre 5687 Family
Hide quick links:
Advertisement
Chapters
Table of Contents
