IG−8
IGNITION (1GR−FE)
−
CRANKSHAFT POSITION SENSOR
CRANKSHAFT POSITION SENSOR
REMOVAL
1.
REMOVE ENGINE UNDER COVER
2.
REMOVE GENERATOR (See page CH−7)
3.
SEPARATE COOLER COMPRESSOR
(a)
Remove the bolt and separate the suction hose sub−
assy.
(b)
Disconnect the cooler compressor assy connector.
(c)
Remove the 4 bolts, and separate the cooler compressor
from the V−ribbed belt tensioner.
A23146
4.
REMOVE CRANKSHAFT POSITION SENSOR
(a)
Disconnect the crankshaft position sensor connector.
(b)
Remove the bolt and crankshaft position sensor.
A23147
IG0MM−01