Save A Backup Of Parameters - YASKAWA CIPR-GA50C series Technical Manual
Ac micro drives for industrial applications. 200 v class, three-phase input: 0.1 to 22 kw. 200 v class, single-phase input: 0.1 to 4.0 kw. 400 v class, three-phase input: 0.37 to 30 kw.
Hide thumbs
Also See for CIPR-GA50C series:
- Installation and operation instruction manual (310 pages) ,
- Technical manual (794 pages) ,
- Installation and operation instruction manual (79 pages)
Table of Contents
Advertisement
4.7 Keypad Operation
Continue to change parameters or push and hold
◆
Save a Backup of Parameters
Show the frequency reference screen in advance.
Note:
Push and hold
to go back to the frequency reference screen from any screen.
Use these steps to save a backup of the drive parameters to the keypad.
Making backups of the parameter settings can save time when setting parameters after replacing a drive. If you set
up more than one drive, you can copy the parameter settings from a drive that completed a test run to the other
drives.
Note:
• Make sure that you stop the motor before you back up parameters.
• The drive does not accept Run commands while it is making a backup.
• Set o3-02 = 0 [Copy Allowed Selection = Disabled] to protect the parameters saved in the keypad.
Push and hold
to go back to the frequency reference screen.
130
Figure 4.18 How to Change the Parameter Setting
to go back to the frequency reference screen.
Figure 4.19 How to Save Backed-up Parameters
YASKAWA SIEPC71061753A GA500 Technical Manual
Advertisement
Table of Contents
Troubleshooting
