YASKAWA CIPR-GA50C series Technical Manual page 303
Ac micro drives for industrial applications. 200 v class, three-phase input: 0.1 to 22 kw. 200 v class, single-phase input: 0.1 to 4.0 kw. 400 v class, three-phase input: 0.37 to 30 kw.
Hide thumbs
Also See for CIPR-GA50C series:
- Installation and operation instruction manual (310 pages) ,
- Technical manual (794 pages) ,
- Installation and operation instruction manual (79 pages)
Table of Contents
Advertisement
■
Remove the Control Circuit Board
Remove the front cover and keypad from the drive.
1.
Push the tabs to the left that hold the control board to the drive.
2.
Pull the left side of the control circuit board out first.
■
Put the Control Circuit Board in a New Drive
Remove the keypad, front cover, and control circuit board of the new drive.
Wire the main circuit terminals of the new drive, then attach the wired control circuit board.
1.
Wire the main circuit terminals.
Note:
To wire terminals +1 and +2, remove the jumper between terminals +1 and +2.
2.
Attach the wired control circuit board to the drive.
Push the control circuit board until the hooks click into place on the drive.
YASKAWA SIEPC71061753A GA500 Technical Manual
Figure 8.20 Unhook the Tabs
Figure 8.21 Remove the Control Circuit Board
Figure 8.22 Wire the Main Circuit Terminals
8.5 Replace the Drive
303
8
Advertisement
Table of Contents
Troubleshooting
