YASKAWA CIPR-GA50C series Technical Manual page 613

■
35: PID Input (Error) Invert
Setting Value Function
35 PID Input (Error) Invert
Note:
Refer to "PID control block diagram" for more information.
■
3E: PID Setpoint Selection 1
Setting Value Function
3E PID Setpoint Selection 1
Refer to "b5-58 to b5-60: PID Setpoint 2 to 4" for more information.
■
3F: PID Setpoint Selection 2
Setting Value Function
3F PID Setpoint Selection 2
Refer to "b5-58 to b5-60: PID Setpoint 2 to 4" for more information.
■
40: Forward RUN (2-Wire)
Setting Value Function
40 Forward RUN (2-Wire)
ON : Forward Run
OFF : Run Stop
Note:
• Turning ON the Forward Run command terminal and the Reverse Run command terminal will cause alarm EF [FWD/REV Run
Command Input Error] and the motor will ramp to stop.
• Initialize the drive with a 2-wire sequence to set the Forward Run command to terminal S1.
• This function will not operate at the same time as H1-xx = 42, 43 [Run Command/FWD/REV Command (2-Wire Seq 2)].
■
41: Reverse RUN (2-Wire)
Setting Value Function
41 Reverse RUN (2-Wire)
ON : Reverse Run
OFF : Run Stop
YASKAWA SIEPC71061753A GA500 Technical Manual
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
Sets the command to turn the terminal ON and OFF to switch the PID input level (polarity).
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
Set this function and H1-xx = 3F [PID Setpoint Selection 2] together. Sets the function to switch the PID setpoint to b5-58 to
b5-60 [PID Setpoint 2 to 4].
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
Set this function and H1-xx = 3E [PID Setpoint Selection 1] at the same time. Sets the function to switch the PID setpoint to b5-
58 to b5-60 [PID Setpoint 2 to 4].
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
Sets the Forward Run command for 2-wire sequence 1. Set this function and H1-xx = 41 [Reverse Run Command (2-Wire Seq)]
at the same time.
Figure 12.71 2-Wire Sequence Wiring Example
V/f OLV OLV/PM AOLV/PM EZOLV OLV/PM
Sets the Forward Run command for 2-wire sequence 1. Set this function and H1-xx = 40 [Forward Run Command (2-Wire
Seq)] at the same time.
12.8 H: Terminal Function Selection
Description
Description
Description
Description
Description
12
613