Keypad: Names And Functions - YASKAWA CIPR-GA50C series Technical Manual

Ac micro drives for industrial applications. 200 v class, three-phase input: 0.1 to 22 kw. 200 v class, single-phase input: 0.1 to 4.0 kw. 400 v class, three-phase input: 0.37 to 30 kw.
Table of Contents

Advertisement

4.2

Keypad: Names and Functions

Symbol
Name
A
USB Terminal
RUN Key
B
STOP Key
C
LO/RE LED
D
ALM/ERR LED
E
READY LED
F
YASKAWA SIEPC71061753A GA500 Technical Manual
Figure 4.1 Keypad
Table 4.1 Keypad: Names and Functions
Insertion point for a USB cable. Uses a USB cable (USB standard 2.0, type A - mini-B) to connect the keypad to a PC.
Starts the drive in LOCAL Mode.
Starts the operation in Auto-Tuning Mode.
Note:
Before you use the keypad to operate the motor, push
Stops drive operation.
Note:
Uses a stop-priority circuit. Push
external Run command source (REMOTE Mode). To disable
Disabled].
Illuminated: The keypad controls the Run command (LOCAL Mode).
OFF: The control circuit terminal or serial transmission device controls the Run command (REMOTE Mode).
Note:
• LOCAL: Operated using the keypad. Use the keypad to enter Run/Stop commands and the frequency reference command.
• REMOTE: Operated from the control circuit terminal or serial transmission. Use the frequency reference source entered in b1-01
and the Run command source selected in b1-02.
Illuminated: The drive detects a fault.
OFF: There are no drive faults or alarms.
Flashing:
• An alarm
• Operation Errors
• An Auto-Tuning error
Note:
The LED will illuminate to identify a fault if the drive detects a fault and an alarm at the same time.
Illuminated: The drive is operating or is prepared for operation.
OFF:
• The drive detects a fault.
• There is no fault and the drive received a Run command, but the drive cannot operate. For example, in Programming Mode.
Flashing: The drive is in STo [Safe Torque OFF] state.
Flashing quickly: The voltage of the main circuit power supply decreased, and the external 24 V power supply provides the only power
to the drive.

4.2 Keypad: Names and Functions

Function
on the keypad to set the drive to LOCAL Mode.
to stop the motor. This will also stop the motor when a Run command is active at an
priority, set o2-02 = 0 [STOP Key Function Selection =
4
113

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ga500 series

Table of Contents