Sub-Chart A-1: Induction Motor Auto-Tuning And Test Run Procedure; Sub-Chart A-2: Pm Motor Auto-Tuning And Test Run Procedure - YASKAWA CIPR-GA50C series Technical Manual
Ac micro drives for industrial applications. 200 v class, three-phase input: 0.1 to 22 kw. 200 v class, single-phase input: 0.1 to 4.0 kw. 400 v class, three-phase input: 0.37 to 30 kw.
Hide thumbs
Also See for CIPR-GA50C series:
- Installation and operation instruction manual (310 pages) ,
- Technical manual (794 pages) ,
- Installation and operation instruction manual (79 pages)
Table of Contents
Advertisement
4.5 Start-up Procedures
◆
Sub-Chart A-1: Induction Motor Auto-Tuning and Test Run Procedure
◆
Sub-Chart A-2: PM Motor Auto-Tuning and Test Run Procedure
Sub-Chart A-2 gives the basic steps to start up the drive for a PM motor.
WARNING! Crush Hazard. Test the system to make sure that the drive operates safely after you wire the drive and set
parameters. If you do not test the system, it can cause damage to equipment or serious injury or death.
124
Figure 4.12 Induction Motor Auto-Tuning and Test Run Procedure
YASKAWA SIEPC71061753A GA500 Technical Manual
Advertisement
Table of Contents
Troubleshooting
