YASKAWA CIPR-GA50C series Technical Manual page 589

Note:
The H5-11 [Comm ENTER Command Mode] setting makes the RAM enter command necessary or not necessary to write parameters
over network communication. When F6-32 = 0, 1, or 2, the H5-11 setting does not have an effect. The RAM enter command is always
necessary to write parameters.
0 : PPO Type
1 : Conventional
2 : PPO (bit0)
This function operates when bit 0 and bit 4 in the register STW have values of 1 (operate). Refer to the
PROFIBUS-DP communication manual for more information.
3 : PPO (Enter)
4 : Conventional (Enter)
5 : PPO (bit0, Enter)
This function operates when bit 0 and bit 4 in the register STW have values of 1 (operate). Refer to the
PROFIBUS-DP communication manual for more information.
■
F6-35: CANopen Node ID Selection
No.
Name
(Hex.)
F6-35 CANopen Node ID
Selection
(03D0)
Note:
Be sure to set an address that is different than all other node addresses. Do not set this parameter to 0. Incorrect parameter settings will
cause AEr [Station Address Setting Error] errors and the L.ERR LED on the option will come on.
■
F6-36: CANopen Communication Speed
No.
Name
(Hex.)
F6-36 CANopen Communication
Speed
(03D1)
0 : Auto-detection
The drive detects the network communication speed and automatically adjusts the communications speed.
1 : 10 kbps
2 : 20 kbps
3 : 50 kbps
4 : 125 kbps
5 : 250 kbps
6 : 500 kbps
7 : 800 kbps
8 : 1 Mbps
■
F6-50: DeviceNet MAC Address
No.
Name
(Hex.)
F6-50 DeviceNet MAC Address
(03C1)
Note:
Be sure to set a MAC address that is different than all other node addresses. Do not set this parameter to 0. Incorrect parameter settings
will cause AEr [Station Address Setting Error] errors and the MS LED on the option will flash.
YASKAWA SIEPC71061753A GA500 Technical Manual
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
Sets the node address for CANopen communication. Restart the drive after you change the
parameter setting.
V/f OLV OLV/PM AOLV/PM EZOLV OLV/PM
Sets the CANopen communications speed. Restart the drive after you change the parameter
setting.
V/f OLV OLV/PM AOLV/PM EZOLV OLV/PM
Sets the MAC address for DeviceNet communication. Restart the drive after you change the
parameter setting.
Description
Description
Description
12.7 F: Options
Default
(Range)
0
(0 - 126)
Default
(Range)
0
(0 - 8)
Default
(Range)
0
(0 - 64)
12
589