Wiring The Control Circuit Terminal - YASKAWA CIPR-GA50C series Technical Manual

3.5 Control Circuit Wiring
A - Terminal block (TB2)
B - Terminal block (TB1-1)
■
Control Circuit Wire Gauges and Tightening Torques
Use the tables in this section to select the correct wires. Use shielded wire to wire the control circuit terminal
block. Use crimp ferrules on the wire ends to make the wiring procedure easier and more reliable.
Terminal
Terminal
Block
TB1-1 PS, S1 - S7, SN, SC, SP
TB1-2 AM, AC, A1, A2, +V, H1, H2, HC
TB1-3 MP, RP, AC, D+, D-, P1, C1, P2, C2
TB2 MA, MB, MC
Crimp Ferrules
Attach an insulated sleeve when you use crimp ferrules. Refer to
dimensions and model numbers of crimp ferrules.
Use the CRIMPFOX 6, a crimping tool made by PHOENIX CONTACT.
Wire Gauge
mm 2 (AWG)
0.25 (24)
0.34 (22)
0.5 (20)
◆

Wiring the Control Circuit Terminal

WARNING! Electrical Shock Hazard. Do not remove covers or touch circuit boards while the drive is energized. If you touch the
internal components of an energized drive, it can cause serious injury or death.
86
Figure 3.35 Control Circuit Terminal Arrangement
Table 3.12 Control Circuit Wire Gauges and Tightening Torques
Recommended Gauge
mm
Figure 3.36 External Dimensions of Crimp Ferrules
Table 3.13 Crimp Ferrule Models and Sizes
Model L (mm)
AI 0.25-8YE 12.5
AI 0.34-8TQ 12.5
AI 0.5-8WH,
14
AI 0.5-8OG
C - Terminal block (TB1-2)
D - Terminal block (TB1-3)
Bare Wire
Applicable Gauge
2 (AWG) mm 2 (AWG)
• Stranded wire
0.25 - 1.0
0.75 (24 - 17)
(18) • Solid wire
0.25 - 1.5
(24 - 16)
• Stranded wire
0.25 - 1.5
0.75 (24 -16)
(18) • Solid wire
0.25 - 1.5
(24 - 16)
Table 3.13
L1 (mm)
8
8
8
YASKAWA SIEPC71061753A GA500 Technical Manual
Crimp Ferrule
Recommended Gauge Applicable Gauge
mm 2 (AWG)
0.5
(20)
0.5
(20)
for the recommended external
φd1 (mm)
0.8
0.8
1.1
mm 2 (AWG)
0.25 - 0.5
(24 - 20)
0.25 - 1.0
(24 - 17)
φd2 (mm)
2.0
2.0
2.5