Drive Mode And Programming Mode - YASKAWA CIPR-GA50C series Technical Manual

4.4 Drive Mode and Programming Mode

4.4

Drive Mode and Programming Mode

The keypad display of this drive has two modes: Drive Mode and Programming Mode.
• Drive Mode
Use this mode to operate the drive. These operations are available:
– Monitor operation statuses (for example, output frequency, output current, and output voltage)
– Set parameters that you can set while the drive is operating (for example, d1-01 to d1-17). Refer to
Details on page 455 for more information.
• Programming Mode
Use this mode to set parameters. These operations are available:
– Examine and set the parameters that are not at default settings (Verify Mode)
– See and set the basic parameters necessary for the drive operation (Setup Mode)
– See and set all parameters (Parameter Setting Mode)
– Automatically set motor parameters (Auto-Tuning Mode)
Table 4.3 gives information about the functions you can access when you push
Note:
You can use b1-08 [Run Command Select in PRG Mode] to set the drive to accept Run commands from an external source while in
Programming Mode.
• Set b1-08 = 0 [Disregard RUN while Programming] to reject the Run command from an external source while in Programming Mode.
• Set b1-08 = 1 [Accept RUN while Programming] to accept the Run command from an external source while in Programming Mode.
• Set b1-08 = 2 [Allow Programming Only at Stop] to prevent changes from Drive Mode to Programming Mode.
LED Display Description
Mode
Frequency
reference
display
Monitor display The keypad shows Ux-xx [Monitor].
Output voltage
display
Drive Mode
Output current
(Operation of
display
the motor and
monitoring of
operation Output
status) frequency
indicator
Forward/reverse
selection
Auto-Tuning
Mode
Parameter
Setting Mode
Programming
Mode
Setup Mode
(Parameter
Settings)
Verify Menu
118
Table 4.3 Overview of the Modes
You can set and monitor frequency references. Refer to
values and how to change them.
Note:
You can change what is shown on the keypad when you energize the drive. Use o1-02 [Monitor
Selection at Power-up] to set the items. When A1-02 = 6 [Control Method Selection = AOLV/PM],
the display unit is %.
You can monitor the output voltage reference.
Use o1-01 [User Monitor Selection] to change the items shown on this display.
You can monitor the output current.
You can monitor the frequency output from the drive.
: Motor rotates in forward direction
: Motor rotates in reverse direction
Note:
For applications where the motor must not rotate in reverse direction (for example, for fans and
pumps), you can use b1-04 [Reverse Operation Selection] to prevent reverse rotation.
How to set reverse operation
The drive automatically calculates and sets the motor parameters.
You can see and set all parameters.
You can see and set the basic parameters necessary for drive operation.
Note:
The parameters shown change when the setting of A1-06 [Application Preset] changes. Refer to
for more information.
You can examine and set the parameters that are not at default settings.
/
Description
118 for more information about frequency setting
YASKAWA SIEPC71061753A GA500 Technical Manual
Parameter
.
Ref.
-
-
333
-
-
-
134
135
136
120
119
133
120