Power Steering Gear Installation; Install Ps Gear Assembly - Toyota Celica 2000 Repair Manual

. - · . \
N
N
POWER STEERING GEAI'1
STEERING
INSTALLATION
1 . INSTALL ENGINE REAR MOUNT INSULATOR AND
ENGINE REAR MOUNT BRACKET
Install the engine rear mount bracket with the 3 bolts.
{a)
Torque: 64 N-m (655 kgl-cm, 47 1t-lbl)
Instal! the engine rear mount insulator with the through
(b)
boll.
Torque: 87 N·m (890 kgf.cm, 64 ft·lbf)
2.

INSTALL PS GEAR ASSEMBLY

(a) Align the match marks on the intermediate extension and
control valve shaft.
(b) Install the boll.
Torque: 35 N-m (360 kgl-cm, 26 ft-lbf)
(c) Install the PS gear assembly with the 4 bolts to the front
suspension member.
Torque: 58 N-m (591 kgf-cm, 43 ft-lbf)
3. INSTALL FRONT SUSPENSION MEMBER WITH LOW­
ER SUSPENSION ARM AND PS GEAR ASSEMBLY
Install the front suspension member with lower suspension arm
and PS gear assembly wlth tho 6 bolts (bolt C,
Torque:
Bolt C: 157 N-m (1 ,600 kgf-cm, 116 ft-lbf)
Bolt D : 157 N·m (1 ,600 kgf-cm, 1 1 6 ft-lbl)
Bolt E: 39 N-m (400 kgf.cm, 29 ft-lbf)
4 .
CONNECT ENGINE FRONT MOUNT INSULATOR AND
FRONT SUSPENSION MEMBER
Connect the engine front mount insulator and front suspension
member with the 2 bolts (bolt B).
Torque: 52 N-m (530 kgf.cm, 38 ft·lbf)
5. CONNECT ENGINE REAR MOUNT INSULATOR AND
FRONT SUSPENSION MEMBER
Connect the engine rear mount insulator and front suspension
member with the bolt (bolt A) and 3 nuts.
Torque: 52 N-m (530 kgf.cm, 38 ft-lbt)
6.
CONNECT STABILIZER BAR
(a ) Connect the stabilizer bar with the nut.
Torque: 44 N·m (449 kgf.cm, 32 ft.Jbt)
Employ the same manner described above to the other
{b )
side.
7. CONNECT LOWER BALL JOINT TO LOWER SUSPEN­
SION ARM (See page SA--45)
SR-51
0
and E).