Schematic And Routing Diagram - Suzuki SX4 Service Manual

The alarm stops under either of the following conditions.
• Ignition switch is turned ON
• A certain time has elapsed since the alarm started
For selection of the mode of the security alarm system, refer to "Security Alarm Mode Selection Procedure (If
Equipped)".
Input / Output Table
Input
Door request switch signal
Keyless entry transmitter
Door switch status
Door lock status
Ignition switch
Body Electrical Control System Wiring Circuit Diagram
NOTE
This wiring diagram shows circuits related to only BCM, not the entire circuits of BCM and junction
block. Refer to "Power Supply Diagram in Section 9A" for wiring circuits other than the figure below.

Schematic and Routing Diagram

Body Electrical Control System:
Horn relay
Hazard warning relay
Warning buzzer
BCM
(located in BCM)
Theft deterrent light
(in information display)
Output
I5RS0CA20003-01
S7RW0AA202001
10B-4