On Vehicle Service; Blower Motor; Blower Motor Resistor - Suzuki RA410 Manual

1A-6 HEATER AND VENTILATION

ON VEHICLE SERVICE

BLOWER MOTOR

REMOVAL
1) Disconnect negative (–) cable at battery.
2) Disable air bag system, if equipped.
Refer to DISABLING AIR BAG SYSTEM in Section 10B.
1
3) Remove column hole cover.
4) Disconnect blower motor coupler.
5) Remove blower motor.
INSPECTION
Check continuity between two terminal as shown in figure.
If check results are continuity, proceed to next operation check, if
not replace.
Connect battery to blower motor as shown, then check that the
blower motor operates smoothly.
INSTALLATION
1) Reverse removal procedure for installation.
2) Enable air bag system, if equipped.
Refer to ENABLING AIR BAG SYSTEM in Section 10B.

BLOWER MOTOR RESISTOR

REMOVAL
1) Disconnect negative (–) cable at battery.
2) Disable air bag system, if equipped.
Refer to DISABLING AIR BAG SYSTEM in Section 10B.
3) Disconnect resistor coupler.
4) Remove blower motor resistor (1) as shown in figure.
1