Starting The First Management Session With A Dhcp Server; Starting The First Management Session With A Direct Connection; Figure 49: Login Window - Allied Telesis GS950 PS V2 Series Installation Manual

Chapter 7: Powering On the Switch
Starting the First
Management
Session with a
DHCP Server
Starting the First
Management
Session with a
Direct
Connection
86
This procedure explains how to start the first management session on the
GS950/28PS V2 Switch when the LAN port is connected to a network that
has a DHCP server. To start the management session, perform the
following procedure:
1. Add the GS950/28PS V2 Switch to the DHCP server. The MAC
address for the switch can be found on a label on the back panel. The
switch's configuration on the server should include an IPv4 address,
subnet mask, and default gateway, if necessary.
2. Connect at least one port on the GS950/28PS V2 Switch to a network
device, such as another Ethernet switch.
3. Power on the GS950/28PS V2 Switch.
4. Start the web browser on your computer.
5. Enter the IP address of the switch in the URL field of the browser. This
is the IP address assigned to the unit by the DHCP server. If you do
not know the address, refer to the DHCP server.
You should see the login window in Figure 49.
6. Enter "manager" for the user name and "friend" for the password. The
user name and password are case-sensitive.
7. Click the Sign In button.
To start the management session with a direct Ethernet connection
between your computer and the GS950/28PS V2 Switch, perform the
following procedure:
1. Connect one end of a network cable to any port on the switch and the
other end to the Ethernet network port on your computer.
2. Change the IP address on your computer to 192.168.1.n, where n is
any number from 2 to 254. Refer to the documentation that
accompanies your computer for instructions on how to set the IP
address.
Figure 49. Login Window