Table of Contents
Advertisement
Chapter 5: Starting a Management Session
Enabling HTTP
Server
Saving the
Changes to a
Configuration
File
Ending the
Management
Session
42
DHCP Client.............Disabled
Directed broadcast......No
-----------------------------------------------
To enable HTTP Server, perform the following procedure:
1. Log in to the switch as shown in "Starting the Initial Management
Session" on page 40.
2. Enable HTTP Server.
Manager sales> enable http server
You can access the switch through the Web interface.
3. To confirm that HTTP Server is enabled, use the
command.
server
Manger sales> show http server
HTTP Server Module Configuration
------------------------------------
Status
HTTP Server Listen Port
------------------------------------
To save your changes to a startup configuration file, perform the following
procedure:
1. To save your changes, create a new configuration file.
Manager sales> create config=config1.cfg
The config1.cfg file is created and your changes are saved into the file.
2. Specify the new file as the startup configuration file.
Manager sales> set config=config1.cfg
The config1.cfg file is now the startup configuration file.
To end the management session, enter the following command
Manager sales> logoff
show http
: Enabled
: 80
Advertisement
Table of Contents
