BGP Commands
show ip bgp dampening
Displays the BGP route dampening settings.
show ip bgp dampening
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
This command shows the setting for dampening on the router, assuming it is enabled.
Examples
-> show ip bgp dampening
Admin Status
Half life value (seconds)
Reuse value
Suppress value
Max suppress time (seconds)
output definitions
Admin Status
Half life value
Reuse value
Suppress value
Max Suppress time
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
= disabled,
= 300,
= 200
= 300,
= 1800,
Indicates whether route dampening is enabled or disabled. This value
is configured through the
The half-life interval, in seconds, after which the penalty value for a
reachable route will be reduced by half. This value is configured
through the
ip bgp dampening
The value that the route flapping metric must reach before this route is
re-advertised. This value is configured through the
command.
The number of route withdrawals necessary to begin readvertising a
previously suppressed route. This value is configured through the
bgp dampening
command.
The maximum time (in seconds) that a route will be suppressed. This
value is configured through the
March 2011
show ip bgp dampening
ip bgp dampening
command.
command.
ip bgp dampening
ip bgp dampening
ip
command.
page 19-153