qos port default classification
Specifies the default egress priority value to use for IP traffic ingressing on trusted ports.
qos port slot/port default classification {802.1p | dscp}
Syntax Definitions
slot/port
802.1p
dscp
Defaults
parameter
802.1p | dscp
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
The egress priority assigned to an IP packet received on a trusted port is based on the DSCP value of
the packet unless 802.1p is specified using this command.
•
The default classification priority is not used if there is a matching QoS policy rule that sets the egress
priority value.
•
This command does not affect Layer 2 traffic, which is always classified with 802.1p.
•
In some network situations, some IP traffic may be dropped before any QoS rules can take effect for
the traffic.
Examples
-> qos port 8/24 default classification dscp
-> qos port 7/1 default classification 802.1p
Release History
Release 6.6.1; command was introduced.
page 38-52
The slot number and port number of the physical port.
Specifies that the 802.1p value of the flow will be used to prioritize
flows coming in on the port.
Specifies that DSCP value of the flow will be used to prioritize flows
coming in on the port.
default
dscp
OmniSwitch CLI Reference Guide
QoS Commands
November 2009