Intel ITANIUM ARCHITECTURE - SOFTWARE DEVELOPERS MANUAL VOLUME 1 REV 2.3 Manual page 509

10.6.2 IA-32 Virtual Memory References
By definition, IA-32 instruction and data memory references are confined to 32-bits of
virtual addressing, the first 4 G-bytes of virtual region 0. However, IA-32 memory
references can be mapped anywhere within the implemented physical address space by
operating system code.
Virtual addresses are converted into physical addresses through the process defined in
Section 4.1, "Virtual Addressing" on page
resources as follows.
• Region Identifiers
region 0, and use the entire 2
identifiers there is no requirement to flush IA-32 mappings on a context switch.
• Protection Keys
processes within any number of protection domains. If PSR.pk is 1, all IA-32
references search the Protection Key Registers (PKR) for matching keys. If a key is
not found, a Key Miss fault is generated. Otherwise, key read, write, execute
permissions are verified.
• TLB Access Bit
or IA-32 instruction set memory references. Note: the processor does not
automatically set the Access bit in the VHPT on every reference to the page. Access
bit updates are controlled by the operating system.
• TLB Dirty Bit
or IA-32 instruction that stores to a dirty page. Note: the processor does not
automatically set the Dirty bit in the VHPT on every write. Dirty bit updates are
managed by the operating system.
10.6.3 IA-32 TLB Forward Progress Requirements
To ensure forward progress while executing IA-32 instructions, additional TLB resources
and replacement policies must be defined over and above the definition given in
Section 4.1.1.2, "Translation Cache (TC)" on page
accesses may not be aligned resulting in a worst case scenario for two possible pages
being referenced for every memory datum referenced during the execution of an IA-32
instruction. Furthermore, the worst case non-intercepted IA-32 opcode can reference
up to 4 independent data pages.
The Translation Cache's (TC) are required to have the following minimum set of
resources to ensure forward progress. Given that software TLB fills can be used to
insert entries into the TLB and a hardware page table walker is not necessarily used,
the following requirements must be satisfied by the processor:
• Instruction Translation Cache
entries in a fully associative design. Replacement algorithms must not consistently
displace the last 2 entries installed by software.
• Data Translation Cache
fully associative design. Replacement algorithms must not consistently displace the
last 8 entries installed by software or the last 8 translations referenced by an IA-32
instruction.
®
Volume 2, Part 1: Itanium Architecture-based Operating System Interaction Model with IA-32 Applications
Operating systems can place IA-32 processes within virtual
–
24
region identifier name space. By using region
Operating systems can place mappings used by IA-32
–
If this bit is zero, an Access Bit fault is generated during Itanium
–
If this bit is zero, a Dirty bit fault is generated during any Itanium
–
at least 1 way set associative with 2 sets, or 2
–
at least 4 way set associative with 2 sets, or 8 entries in a
–
2:45. IA-32 references use the Itanium TLB
2:49. IA-32 instructions and data
2:261