260If-01 Modules - YASKAWA JEPMC-MP2300-Y Series User Manual

5.5.9 260IF-01 Modules

When self-configuration is executed, the following parameter settings will be made for the
DeviceNet interface and RS-232C interface of 260IF-01 Modules.
( 1 ) DeviceNet Communication
Item
Master/Slave specification
MAC ID
Communication cycle time
I/O allocations
I/O leading register number
I/O end register number
( 2 ) RS-232C Interface
Item
Communication protocol
Master/Slave
Device address
Serial interface
Communication mode
Data length
Parity
Stop bits
Baud rate
Transmission delay
Automatic reception
Interface register settings at the
slave
5.5 Definition Data Refreshed by Self-configuration and Allocation Examples
Depends on switch settings.
Depends on switch settings.
Master: 300 ms
Slave: 0 ms
Depends on switch settings.
Depends on switch settings.
Depends on switch settings.
MEMOBUS
Slave
1
RS-232C
RTU
8 bits
Even
1 bit
19.2 Kbps
Disable
Enable
Reading input relays
Reading input registers
Reading/writing coils
Reading/writing holding registers
Writing range for coil holding
registers
−
−
Engineering communication connection with the MPE720 is possible using self-configuration.
Also, depending on the settings of connected devices, MEMOBUS message communication may
be possible using the automatic reception function.
Setting
Setting
Leading Register Number of Words
IW0000
IW0000
MW00000
MW00000
MW00000
LO: MW00000
HI: MW65534
32,768
32,768
65,535
65,535
−
−
−
5-41