YASKAWA JEPMC-MP2300-Y Series User Manual page 166

3 Module Specifications
3.5.3 260IF-01 Module
( 2 ) LED Indicators and Switch Settings
[ a ] Indicators
MS NS
STRX
[ b ] Switch Settings
DR0
DR1
1
2
INIT
TEST
OFF ON
10
1
3-58
The following table shows the status of the 260IF-01 Module LED indicators.
Indicator
Green
MS
Red
(2-color LED)
Not lit
Green
Green blinking
NS
Red
(2-color LED)
Red blinking
Not lit
Green lit/blinking
STRX
(mounted on PCB)
Not lit
The following table shows the 260IF-01 Module switch settings.
Switch Name
Baud Rate
DR0
Setting 0
Baud Rate
DR1
Setting 1
DR0
DR1
Baud Rate
× 1
Master/Slave
Mode
× 2
Self-diagnosis
(DeviceNet)
INIT
Initial Startup
TEST
TEST
Node Address
× 10
10s Digit Setting
Node Address 1s
× 1
Digit Setting
Display
Normal operation
Module error
Module power supply disconnected
Normal operation
No I/O allocation, connection being established
Error (Bus OFF, duplicated MAC ID)
Communication error
Communication power supply disconnected, checking
for duplicated MAC ID
Transmitting or receiving RS-232C data
No RS-232C data transmission or reception
Status/Set-
ting Range
The following baud rates can be selected by the combination of
ON/OFF settings of DR0 and DR1.
OFF OFF
OFF ON
125 kbps 250 kbps
ON
Used in master mode.
OFF
Used in slave mode.
Executes DeviceNet self-diagnosis when turned
ON
ON the power supply.
Does not execute self-diagnosis. Normally,
OFF
always leave turned OFF.
For engineering communications. Starts RS-
232C (PORT) using default parameters except
ON
setting of automatic reception functions. Given
higher priority than Basic Module Flash Startup
and Self-configuration Startup.
Set to OFF for Basic Module Flash Startup and
OFF
Self-configuration Startup.
ON
System use
OFF
Normal operation (Always leave set to OFF.)
0 to 6
Set the node address in the range from 1 to 64.
(Rotary decimal switch)
0 to 9
Status
Function
ON ON
OFF ON
Communica-
500 kbps tion not possi-
ble
Defaul
t
OFF
OFF
OFF
OFF
OFF
OFF
0
1