YASKAWA JEPMC-MP2300-Y Series User Manual page 160

3 Module Specifications
3.5.1 218IF-01 Module
[ b ] Switch Settings
INIT
TEST
OFF ON
[ c ] Offline Self-diagnostic Test
Item
Flash Checksum
Error
SRAM Error
CPU Interface Error
Communication
Error
Watchdog Error
( 3 ) Specifications
[ a ] Hardware Specifications.
Item
Classification
Name
Model
Communication Ports
Indicators
3-52
The following table shows the 218IF-01 Module switch settings.
Switch Name
INIT
Initial Startup
TEST
TEST
Turn the TEST switch ON and the INIT switch OFF, and then turn ON the power supply to execute
the Offline Self-diagnostic Test. The following table shows the status of the LED indicators when the
218IF-01 Module detects a malfunction.
Details
A flash memory checksum error has been
detected.
A SRAM hardware error has been detected.
A CPU data transmission error has been
detected.
A communication error has been detected.
A watchdog timeout error has been detected.
* Indicates the number of blinking.
The specifications of 218IF-01 Module are as follows.
Communication Module
218IF-01
JAPMC-CM2300
RS-232C 1 port（PORT）
Ethernet 1 port（10Base-T）
Module status LED indicators
RUN (green)
ERR (red)
STRX (green)
COL (red)
TX (green)
RX (green)
Setting
For engineering communications. Starts the
Module using the default parameters except setting
ON
of automatic reception functions. Given higher
priority than the Basic Module Flash Startup and
Self-configuration Startup.
Set to OFF for Basic Module Flash Startup and
OFF
Self-configuration Startup.
ON
System use
OFF
Normal operation (Always leave set to OFF.)
RUN
Not lit
Specifications
Function
LED Indicators
ERR TX
Blinking
∗
(twice)
Blinking
Not lit
∗
(3 times)
Blinking
∗
(5 times)
Blinking
Depends on status.
∗
(4 times)
Blinking
Depends on status.
∗
(15 times)
Factory
Setting
OFF
OFF
RX
Not lit