Module Connections - YASKAWA JEPMC-MP2300-Y Series User Manual

4 Mounting and Wiring
4.3.2 SVA-01 Module Connections
4.3.2 SVA-01 Module Connections
( 1 ) Connectors
[ a ] Servo Interface Connectors (CN1 and CN2)
These connectors connect the SVA-01 Module to two SERVOPACKs.
They are connected using the following standard cable.
• JEPMC-W2040-
[ b ] 24-V Input Connector (CN3)
[ c ] Connector Specifications
Connector
Name
Servo Interface
Connector 1 and
Connector 2
24-V Input
Connector
4-22
The Servo interface connectors connect the SVA-01 Module to analog Servos.
(For SGDH, SGDM, and SGDS SERVOPACKs)
The user must provide cables for SGDA and SGDB SERVOPACKs.
This connector connects the SVA-01 Module to +24 VDC as a Servo I/O power supply.
A screw terminal connector is used (BL3.5/2F-AU manufactured by Weidmuller).
Pin No.
+24V
ON
DC IN
* Refer to 2.2.3 (1) (d) Connection Procedure for 24-V Input Cable of Machine Controller
MP220/MP2300 Motion Module User's Manual (Manual No. SIEP C880700 16 ) for infor-
mation on how to connect the 24-V input cable.
The following table shows the connector specifications
No. of
Name Pins
Module Side
CN1
36
10236-52A2JL
CN2
2
CN3 −
Signal Name
2 24V
1 0V
Connector Model
Cable Side
• Connector body:
10136-3000VE
• Shell:
10336-52A0-008
(Screw locking)
10336-52F0-008
(One-touch locking)
• BL3.5/2F-AU
Name
+24 VDC input
0 V
.
Cable Model Numbers
Manufacturer
JEPMC-W2040-
(For the SGDH, SGDM,
3M
and SGDS
SERVOPACKs)
The CN3 connector is
included with the SVA-
Weidmuller 01 Module, but a cable is
not included. The user
must connect the cable.