218If-01 Modules - YASKAWA JEPMC-MP2300-Y Series User Manual

5 Outline of Motion Control Systems

5.5.7 218IF-01 Modules

5.5.7 218IF-01 Modules
( 1 ) Ethernet Interface
Local IP address
Subnet mask
Gateway IP address
System port
(engineering port)
TCP zero window timer value
TCP resend timer value
TCP end timer value
IP build timer
Maximum packet length
( 2 ) RS-232C Interface
Communication protocol
Master/Slave
Device address
Serial interface
Communication mode
Data length
Parity
Stop bits
Baud rate
Transmission delay
Automatic reception
Interface register settings at the
slave
5-38
When self-configuration is executed, the following parameter settings will be made for the Ethernet
interface and RS-232C interface of 218IF-01 Modules.
Item
192.168.1.1
255.255.255.0
0.0.0.0
10000 (UDP)
3 s
500 ms
60 s
30 s
1,500 bytes
Engineering communication connection with the MPE720 is possible using self-configuration.
To perform MEMOBUS message communication, the MSG-SND (MSG-RCV) function is required.
Item
MEMOBUS
Slave
1
RS-232C
RTU
8 bits
Even
1 bit
19.2 Kbps
Disable
Enable
Reading input relays
Reading input registers
Reading/writing coils
Reading/writing holding registers
Writing range for coil holding
registers
−
−
Engineering communication connection with the MPE720 is possible using self-configuration.
Also, depending on the settings of connected devices, MEMOBUS message communication may
be possible using the automatic reception function.
Setting
Setting
Leading Register Number of Words
IW0000
IW0000
MW00000
MW00000
MW00000
LO: MW00000
HI: MW65534
32,768
32,768
65,535
65,535
−
−
−