Dlp-H81 Apply Alarm Profiles To Ports - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
If you want to download a profile that is stored locally or on a network drive, click From File in the Load
Step 6
Profile(s) dialog box.
a.
b.
c.
Click OK.
Step 7
The downloaded profile appears at the right side of the Alarm Profiles window.
Right-click anywhere in the downloaded profile column to display the profile editing shortcut menu.
Step 8
Click Store.
Step 9
In the Store Profile(s) dialog box, click To Node(s).
Step 10
a.
b.
Step 11 Return to your originating procedure (NTP).

DLP-H81 Apply Alarm Profiles to Ports

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the node view, double-click a card to open the card view.
Step 1
Click the Provisioning > Alarm Profiles > Alarm Profile Editor tabs.
Step 2
To apply profiles on a port basis:
Step 3
a.
b.
78-19416-01
Click Browse.
Navigate to the file location in the Open dialog box.
Click Open.
All default or user-defined severity settings that are Critical (CR) or Major (MJ) are demoted
Note
to Minor (MN) in Non-Service-Affecting (NSA) situations as defined in Telcordia GR-474.
Choose the nodes where you want to save the profile:
If you want to save the profile to only one node, click the node in the Node Names list.
•
If you want to save the profile to all nodes, click Select All.
•
If you do not want to save the profile to any nodes, click Select None.
•
If you want to update alarm profile information, click Synchronize.
•
Click OK.
This task applies a custom or default alarm severity profile to a port or
ports.
None
DLP-H79 Create a Cloned Alarm Severity Profile, page 16-96
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
In card view, click the port row in the Profile column.
Choose the new profile from the drop-down list.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-99