Idsm-2 Configuration Tasks; Configuring The Catalyst 6500 Series Switch For Command And Control Access To The Idsm-2 - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 10 Configuring the Sensor Using the CLI
Caution

IDSM-2 Configuration Tasks

Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
service-module ids-sensor slot_number/0 shutdown
–
Router#
Shuts down the IDS applications running on the NM-CIDS.
Removing the NM-CIDS without proper shutdown can result in the hard-disk
drive being corrupted. After successful shutdown of the NM-CIDS applications,
Cisco IOS prints a message indicating that you can now remove the NM-CIDS.
– service-module ids-sensor slot_number/0 status
Router#
Provides information on the status of the Cisco IDS software.
• Configure interfaces mode
Router(config-if)# ids-service-module monitoring
You can enable IDS monitoring on a specified interface (or subinterface).
Both inbound and outbound packets on the specified interface are forwarded
for monitoring.
Perform the following tasks to configure the IDSM-2:
Initialize the IDSM-2.
1.
Run the setup command to initialize the IDSM-2.
See Initializing the Sensor, page
Configure the Catalyst 6500 series switch for command and control access to
2.
the IDSM-2.
See Configuring the Catalyst 6500 Series Switch for Command and Control
Access to the IDSM-2, page
Assign the interfaces.
3.
See Assigning and Enabling the Sensing Interface, page
procedure. See Using the TCP Reset Interface, page
the TCP reset interface.
Configure the IDSM-2 to capture traffic for intrusion detection analysis.
4.
See Capturing IDS Traffic, page
10-2, for more information.
10-88, for the procedure.
10-90, for the procedures.
IDSM-2 Configuration Tasks
10-9, for the
8-4, for information on
10-87