Dlp-H39 Provision Ip Settings - Cisco ONS 15310-MA SDH Procedure Manual

•
•
•
Note
Under "Select applicable nodes," deselect any nodes where you do not want to add the user (all network
Step 5
nodes are selected by default).
Click OK.
Step 6
In the User Creation Results dialog box, click OK.
Step 7
Return to your originating procedure (NTP).
Step 8

DLP-H39 Provision IP Settings

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
All network changes should be approved by your network (or LAN) administrator.
Caution
Verify that any IPv4 or IPv6 addresses assigned to the node are unique in the network. Duplicate IP
Caution
addresses in the same network cause loss of visibility.
In node view, click the Provisioning > Network > General tabs.
Step 1
Complete the following information in the fields listed:
Step 2
•
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-52
Password—Type the user password. The password must have a minimum of 6 and a maximum of
20 alphanumeric (a-z, A-Z, 0-9) and special (+, #,%) characters, where at least two characters are
nonalphabetic and at least one character is a special character. For TL1 compatibility, the password
must be 6 to 10 characters, and the first character must be an alpha character. The password cannot
contain the user name.
Confirm Password—Type the password again to confirm it.
Security Level—Choose a security level for the user: RETRIEVE, MAINTENANCE,
PROVISIONING, or SUPERUSER. Refer to the "Security" chapter in the Cisco ONS 15310-MA
SDH Reference Manual for information about the capabilities provided with each level.
Each security level has a different idle time. The idle user timeout is the length of time that CTC
can remain idle before it locks up and the password must be reentered. The default times are:
Retrieve user = unlimited, Maintenance user = 60 minutes, Provisioning user = 30 minutes, and
Superuser = 15 minutes. To change the idle user timeout values, see the
and Change Security" procedure on page
This task provisions IP settings, which includes the IP address, IP address
version, default router, DHCP access, firewall access, and SOCKS proxy
server settings.
None
DLP-H29 Log into CTC, page 16-43
Required
Onsite or remote
Superuser only
Node Address—Type the IP address assigned to the ONS 15310-MA SDH node.
10-6.
Chapter 16 DLPs H1 to H99
"NTP-H83 Modify Users
78-19416-01