Chapter 5
Create Circuits and VT Tunnels
DLP-B246 Provision E-Series Ethernet Card Mode
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You cannot change the mode while the Ethernet card is carrying circuits. If you want change the card
Caution
mode, delete any circuits that it carries first. See the
page
In the network view, double-click the node containing the E-Series Ethernet card you want to provision,
Step 1
then double-click the Ethernet card.
Click the Provisioning > Ether Card tabs.
Step 2
In the Card Mode area, choose one of the following:
Step 3
•
•
•
Multicard EtherSwitch circuits only: repeat Steps
Step 4
will carry the multicard EtherSwitch circuits.
Repeat Steps this task for other nodes as necessary.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-B220 Provision E-Series Ethernet Ports
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security
Display the node view.
Step 1
Double-click the Ethernet card that you want to provision.
Step 2
Click the Provisioning > Ether Port tabs.
Step 3
March 2003
This task provisions an E-Series Ethernet card for multicard EtherSwitch
Group, single-card EtherSwitch, or port-mapped mode.
E-Series Ethernet cards must be installed.
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
8-15.
For multicard EtherSwitch circuit groups, choose Multicard EtherSwitch Group. Click Apply.
For single-card EtherSwitch circuits, choose Single-card EtherSwitch. Click Apply.
For port-mapped circuits, choose port-mapped. Click Apply.
This task enables ports for the E-Series card.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
NTP-B145 Create an E-Series Multicard EtherSwitch Manual Cross-Connect
"NTP-B152 Delete Circuits" procedure on
2
and
3
for all other Ethernet cards in the node that
Cisco ONS 15327 Procedure Guide, R4.0
5-69