Figure 9-11 Shared Packet Ring Ethernet Circuit - Cisco ONS 15327 User Documentation

Ethernet Circuit Configurations

Figure 9-11 Shared packet ring Ethernet circuit

Backbone router
Access router
Procedure: Provision a Shared Packet Ring
Step 1 Display CTC for one of the ONS 15327 Ethernet circuit endpoints.
Double-click one of the Ethernet cards that will carry the circuit.
Step 2
Click the Provisioning > Card tabs.
Step 3
Under Card Mode, verify that Multi-card EtherSwitch Group is checked.
Step 4
If Multi-card EtherSwitch Group is not checked, check it and click Apply.
Step 5
Display the node view.
Step 6
Repeat Steps 2–6 for all other Ethernet cards in the ONS 15327 that will carry the shared packet ring.
Step 7
Step 8 Navigate to the other ONS 15327 endpoint.
Repeat Steps 2–7.
Step 9
Click the Circuits tab and click Create.
Step 10
The Circuit Creation (Circuit Attributes) dialog box appears.
In the Name field, type a name for the circuit.
Step 11
From the Type pull-down menu, choose STS.
Step 12
Note
Step 13 From the Size pull-down menu, choose the size of the circuit.
For shared packet ring Ethernet, valid circuit sizes are STS-1 and STS-3c.
Verify that the Bidirectional check box is checked.
Step 14
Cisco ONS 15327 User Documentation, R3.3
9-10
ONS 15327
Access router
The VT and VT Tunnel types do not apply to Ethernet circuits.
SONET Ring
ONS
ONS 15327
Access router
Chapter 9 Ethernet Operation
Access router
Access router
15327
Access router
SONET
Ethernet
June 2002