Status Indicators And Leds For Gigabit Ethernet Ports - Cisco Catalyst 8300 Series Hardware Installation Manual

Overview of Cisco Catalyst 8300 Series Edge uCPE
Note
• Network Interface Module (NIM): The device supports one NIM when you need additional ports. See
• Pluggable Interface Module (PIM): The device supports one PIM for cellular connectivity. See
Note

Status Indicators and LEDs for Gigabit Ethernet Ports

The front panel Gigabit Ethernet ports have eight ports: four RJ45 ports and four SFP ports.
Figure 6: Status and LED indicators
• Supports maximum of 128 GB of main memory with 4 x 32 GB DDR4
DIMMs.
• Four DIMM slots, numbered from 0 to 3 with a frequency of 3200 MHz.
• Uses DDR4 DIMMs for the main memory.
• Memory DIMM combinations allowed: 1 x 32GB, 2 x 16GB, 2 x 32GB, 4
x 16GB, 4 x 32GB.
data sheet for supported NIMs.
sheet for supported PIMs.
For proper thermal functioning of the system, install and provision a functional
module with a blank filler for all module slots or optional components (PIM,
NIM, E1.S, M.2 and U.2) that do not have a functional module installed.
Status Indicators and LEDs for Gigabit Ethernet Ports
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
data
5