Table of Contents
Advertisement
Install the Device
Connect Interface Ports
You can connect optical interface ports on line cards with other devices for network connectivity.
Connect a Fiber-Optic Port to the Network
Depending on the line card model that you are using, you can use either QSFP+ or QSFP28 transceivers.
Some transceivers work with fiber-optic cables that you attach to the transceivers and other transceivers work
with pre-attached copper cables. When installing fiber-optic cables for a port, you must install SFP transceivers
for 1-Gigabit optical ports or install SFP+ transceivers for 10-Gigabit optical ports or QSFP+ transceivers for
100-Gigabit ports before installing the fiber-optic cable in the transceivers.
Caution
Disconnect Optical Ports from the Network
When you need to remove fiber-optic transceivers, you must first remove the fiber-optic cables from the
transceiver before you remove the transceiver from the port.
Maintain Transceivers and Optical Cables
To maintain high signal accuracy and to prevent damage to the connectors, transceivers and fiber-optic cables
must be kept clean and free of dust. Attenuation (loss of light) is increased by contamination and should be
below 0.35 dB.
Consider the following maintenance guidelines:
• Transceivers are static sensitive. To prevent ESD damage, wear an ESD-preventative wrist strap that is
• Do not remove and insert a transceiver more than it is necessary. Repeated removals and insertions can
• Keep all optical connections covered when not in use. Clean them before use to prevent dust from
• Do not touch the ends of connectors. Touching the ends would leave fingerprints and cause other
• Clean the connectors regularly; the required frequency of cleaning depends upon the environment. In
• Inspect routinely for dust and damage. Clean and then inspect fiber ends under a microscope to determine
Removing and installing a transceiver can shorten its useful life. Do not remove and insert transceivers more
than it is absolutely necessary. We recommended that you disconnect cables before installing or removing
transceivers to prevent damage to the cable or transceiver.
connected to the grounded chassis.
shorten its useful life.
scratching the fiber-optic cable ends.
contamination.
addition, clean connectors if they are exposed to dust or have been accidentally touched. Both wet and
dry cleaning techniques can be effective; refer to your site's fiber-optic connection cleaning procedures.
whether any damage has occurred.
Hardware Installation Guide for Cisco 8011-2X2XP4L PLE Service Endpoint Router
Connect Interface Ports
51
Advertisement
Table of Contents
