Dlp-H190 Provision Ce-100T-8 And Ce-Mr-6 Card Ethernet Ports - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 17 DLPs H100 to H199
If you click cancel while performing a Dual roll in Manual mode and have a valid signal detected on both
Caution
rolls, you will see a dialog box stating that this can cause a traffic hit and asking if you want to continue
with the cancellation. Cisco does not recommend cancelling a dual roll once a valid signal has been
detected. To return the circuit to the original state, Cisco recommends completing the roll, then using
bridge and roll again to roll the circuit back.
From the Node or Network view, click the Circuits > Rolls tabs.
Step 1
Click the rolled circuit that you want to cancel.
Step 2
Click Cancel.
Step 3
Return to your originating procedure (NTP).
Step 4

DLP-H190 Provision CE-100T-8 and CE-MR-6 Card Ethernet Ports

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The user can provision SDH CCAT or VCAT circuits for the CE-100T-8 and CE-MR-6 cards before or
Note
after provisioning the card's Ethernet ports or POS ports. See the
Routed Optical Circuit" procedure on page 5-32
VCAT Circuit" procedure on page
In the node view, double-click the CE-100T-8 or CE-MR-6 card graphic to open the card.
Step 1
Click the Provisioning > Ether Ports tabs.
Step 2
Step 3 For each CE-100T-8 or CE-MR-6 port, provision the following parameters:
•
•
•
78-19416-01
This task provisions the CE-100T-8 and CE-MR-6 card Ethernet ports to
carry traffic.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Port Name—If you want to label the port, enter the port name.
Admin State—Choose unlocked to put the port in service. Putting an Ethernet port into
unlocked-enabled also puts the mapped POS port in unlocked-enabled.
Expected Speed—Choose the expected speed of the device that is or will be attached to the Ethernet
port. If you know the speed, choose 100 Mbps or 10 Mbps (for CE-100T-8), or 1000 Mbps,
100 Mbps, or 10 Mbps (for CE-MR-6) to match the attached device. If you do not know the speed,
choosing Auto enables autonegotiation for the speed of the port, and the CE-100T-8 or CE-MR-6
port attempts to negotiate a mutually acceptable speed with the attached device. If the expected
speed is set to Auto, you cannot enable selective autonegotiation.
or the "NTP-H51 Create an Automatically Routed
5-42, as needed.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
"NTP-H47 Create an Automatically
17-85