Clear The Ms-Rfi Condition - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting

Clear the MS-RFI Condition

SUMMARY STEPS
1. Log into the far-end node of the reporting NCS.
2. Determine whether there are other alarms, especially the LOS(STM1E, STMN).
3. Clear the main alarm. See the appropriate alarm section in this chapter for the procedure.
DETAILED STEPS
Step 1
Log into the far-end node of the reporting NCS.
Step 2 Determine whether there are other alarms, especially the LOS(STM1E, STMN).
Step 3
Clear the main alarm. See the appropriate alarm section in this chapter for the procedure.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
MT-OCHNC
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: OTS
The MT-OCHNC condition occurs when the user provisions (tunes) a specific wavelength for maintenance
on a WXC card from an input port (EXP1-8, ADD-RX) to the output port (COM-TX).
Clear the MT-OCHNC Condition
SUMMARY STEPS
1. Delete the provisioned wavelength that was specifically tuned for maintenance purposes on a WXC card.
DETAILED STEPS
Delete the provisioned wavelength that was specifically tuned for maintenance purposes on a WXC card.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
NO-SHARED-CIPHERS Alarm
Default Severity: Major (MJ), Service Affecting (SA)
http://www.cisco.com/c/en/us/support/index.html
http://www.cisco.com/c/en/us/support/index.html
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Clear the MS-RFI Condition
309