Nmi Clear; Nme Interface - Cisco ONS 15540 ESP Hardware Installation Manual

Cisco ONS 15540 Components
Table 1-10 Flash PC Card Slot LEDs
LED Status
Slot 0 Green
Slot 1 Green

NMI Clear

Note

NME Interface

Table 1-11 NME LEDs
LED Status
Link Green
100 MPS Green
Full Duplex Green
Cisco ONS 15540 ESP Hardware Installation Guide
1-22
Description
Flash PC Card slot 0 is being accessed.
Flash PC Card slot 1 is being accessed.
A recessed push button, labeled NMI CLR, is accessible through the faceplate to
clear an NMI (non-maskable interrupt).
To activate the switch, use a thin tool (such as a small screwdriver)
to press and release the button.
The NME (network management Ethernet) interface supports 10-Mbps or
100-Mbps UTP (unshielded twisted-pair) ports. This RJ-45 interface supports
full-duplex or half-duplex connections.
The NME port on the processor card is a management port that allows multiple
simultaneous Telnet or SNMP network management sessions. The Ethernet port
on the processor card does not route or bridge traffic to other Ethernet ports on the
Cisco ONS 15540. This Ethernet port is a management port only and cannot be
configured as a routing port.
Table 1-11 describes the LEDs used to confirm and troubleshoot the operation of
the NME interface. The LEDs on the processor faceplate indicate the status of the
NME interface.
Description
NME interface is receiving the link integrity signal.
Interface is operating at 100 Mbps.
Interface is operating in full duplex mode.
Chapter 1 Product Overview
78-15095-01